The first step in creating a forensic toolkit is to analyse the XBOX Hard drive. In order to do this you will need the following. 
- An XBOX 360 hard drive.
- A TORX #6 screwdriver
- A TORX #10 screwdriver
- A 3.5” SATA Expansion Bay
The first step is to disassemble the Xbox Drive Case and Remove the Hard drive. To do this you must remove 4 TORX #6 screws marked on the image. (Note: It is important to note that the screw on the top left of the image is underneath the Microsoft Sticker. Removal of this sticker voids the warranty on the drive.)
Once the screws have been removed the cover can be removed from the drive. Next you will remove the 4 TORX#10 screws that hold the drive in place. Once removed the drive will slide out of the bay as per the image below.
The item marked in Yellow in the above image is the drive connection component used to connect the SATA drive into the XBOX 360 drive bay. It is important and will be used later in this project. The final step in this process was to test to ensure the XBOX drive would work outside of the casing.
As per the images below the drive connector component was connected from the SATA drive to the XBOX.
The XBOX was powered on and the drive checked to ensure it was functioning correctly.
with the exception of sata adapter is there any difference between the xbox drive and a standard 2.5" SATA drive?
ReplyDelete@Phil I am just finishing off the research for the next post. This is with respect to the drive itself. From what I have found so far the drive is standard 2.5" SATA. It seems the XBOX however will only accept this particular drive. The XBOX does a hardware specific check or a partiton level check on the drive at boot time. This is still under investigation at present. Keep an eye out for the blog update
ReplyDelete